Training course on Internet of Things, Wearable Device and coding

The Second course of the project: Arduino, Wearable Device and Free Editor at Genoa

This course will be an Introduction to IoT wearable devices for educational purposes;
b) How to use a free software Editor
c) How to connect a free software editor to an open source semplifies electronics prototyping platform;
d) Sensors (First part): Gyroscope, accelerometer, tilt sensor, light sensor, magnetometer.

The venue will be Madlab 2.0 (via della maddalena 121r in Genoa)  the 3d printer and humanoid start up founded by Scuola di Robotica in 2017.

The software that the trainees will use are Scratch, Snap and more.

Leave a comment

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.